Hmmm... I'm still very bad with 3d design stuff. How do you separate them? I would like to print some v4 parts from the printbed002, but struggle with separating them
thanks in advance for any hints.
Sat May 12, 2012 8:34 pm
Joined: Tue Aug 30, 2011 9:41 pm Posts: 106 Location: Devon, UK
Re: Individual Stl files for Orca 0.3
I used solidworks, used the stl's as reference, and took measurements from them; then drew new solid models with solidworks, and exported them as stl's.
Another way of doing it, would be to use netfabb to cut the printbed files into individual parts. This is only easy if parts don't overlap, but you should be able to get most of the parts on their own, then save as individual stl's.
Users browsing this forum: No registered users and 1 guest
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum