 |
 |
 |
|
Page 1 of 1
|
[ 1 post ] |
|
| Author |
Message |
|
Trapper_920
Joined: Fri Feb 03, 2012 1:19 am
Posts: 69
|
 Getting started. Can someone tell me how to walk through and calibrate the 040?
I'd prefer to use ReplicatorG for printing. The software section on mendel-parts has a flag about being outdated. I didn't see any documentation on calibrations in general. The 040 has almost nothing in general.
|
| Wed May 30, 2012 5:42 am |
|
|
|
|
Page 1 of 1
|
[ 1 post ] |
|
Who is online |
Users browsing this forum: No registered users and 2 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
|
|
