The my board is different, i think the old one! I fixed all the movements!! now works fine!! the single problem is the temperature sensor that is not working at all... I hope is a firware problem and not an electronic matter... Thank You All for the support!!

Thank you for the pictures, they are very good for completing my printer

What was the cause of your problem with the Y-axis ?

mfg Chri

You are welcome!! The problem wa the opto sensor!! So thanks to geoffd123!!! two of the pin of the sensor was in short circuit by the metad threated rod... now is working really well all the mechanics!! the single problem is the temperature probe... I've tester it with the multimeter and I think is everything fine... I'm whatching the firmware... maybe there is a problem there...

Thanks !!!

Hmm, ok i already changed the optos between the ports , i`ll check the senors today afternoon again.

mfg Chri

I think I'm near to the solution...

All the connection between the board to the thermistor looks good... I'm watching all the the old and new firmware and I've identificate the part About the themperature sensor... i think is THERMISTORTABLES_H_

On wiki http://reprap.org/wiki/Thermistor I found pieces of firware for each temperature sensor but I can't use it in my because is generating one error during the verify...

Thank you for the help!!

Solved everything with pronterface!!! Thank you all we are official Printing!!!!

Gratulations,

I also just found the problem of my otpo, there is one pin at the Gen6 board missing, its a production failure

mfg Chri