Build Info
(page under construction - last updated 18-5-2012)

Orca v0.42 Manual (UNDER CONSTRUCTION)
(please use this manual untill we have a .pdf manual in the downloads for Orca 040/042)
(note: this is for Orca 0.42, customers with 0.40 can use this but will have small changes)
(note2: the pink parts used in the manual were mostly printed on an Orca 0.40 few months ago.. so dont judge them for quality purposes)

• BOM1 - 1xxx printed plastic parts
• BOM2 - 2xxx sheet material
• BOM3 - 3xxx hardware
• BOM4 - 456xxx other
• INFO1 - General Information
• INFO2 - Preparation
• STEP 01 - Bottom assembly
• STEP 02 - Top assembly
• STEP 03 - Frame assembly
• STEP 04 - Motors
• STEP 05 - Y-sides pre-assembly
• STEP 06 - YZ Frame assembly
• STEP 07 - Y-fin pre-assembly
• STEP 08 - Fit Y-fin on YZ frame
• 09 - Fitting & levelling YZ frame
• 10 - Fitting Z-belt & Z-motor
• 11 - Printbed pre-assembly
• 12 - Fitting printbed
• 13 - X-carriage assembly
• 14 - Fitting X-carriage
• 15 - Extruder pre-assembly
• 16 - Hotend pre-assembly
• 17 - Fitting extruder & hotend
• STEP 18 - Fitting Gen6 Electronics
• STEP 19 - Cabling
• STEP 20 - Firmware updating & settings
• STEP 21 - Printer software & 1st print
• A1 - Software advanced: Skeinforge
• A2 - Maintenance
• A3 - Issue Solving
• A4 - Upgrades / Future
• A5 - Part-nr codes
• A6 - A-Z Index

also check our downloads/manuals & forum & RepRap Orca Wiki page for more info.



Mendel v2

Printed Parts overview


link for all printed part screenshots: /downloads/2d-drawings/Mendel/printed-parts-overview


Extruder
Heated bed