Details
This saves the hazzle with the nichrome wire (And possible failure due to bad wiring). Also it seems to print better quality..
It takes a bit longer to heat up, also I set it a bit higher 215-220 for PLA.
This is just the heat resistor (used as the heating element in alu/brass heaterblocks (v2-v9) for the extruder).
Resistance Value: 6.8Ω (6R8)
Product Diameter 5.5mm
Product Length 12mm
Mounting: Through Hole
Power Rating 3 W
It takes a bit longer to heat up, also I set it a bit higher 215-220 for PLA.
This is just the heat resistor (used as the heating element in alu/brass heaterblocks (v2-v9) for the extruder).
Resistance Value: 6.8Ω (6R8)
Product Diameter 5.5mm
Product Length 12mm
Mounting: Through Hole
Power Rating 3 W